Eaton BladeUPS Series, Инструкции по установке DOS

Страница: 15 / 32

Eaton BladeUPS DoS Installation Instructions P-164000613—Rev 3 9
Section 6 Equipment Setup
To set up the BladeUPS system, you will need to locate and open both boxes for the two BladeUPS modules,
the two Electronics Modules (EM), the eight battery packs, and the two installation kits.
1. Locate accessory boxes and remove the installation kits. Verify that the following items are in each
installation kit:
l
UPS documentation and software tools:
l
IPSS Software Suite CD and Firmware CD
l
Installation instructions and a standard BladeUPS User’s Guide
l
(2) Door keys
l
(2) Hot Sync CAN Bridge Cards, and wiring accessories:
l
(1) CAN Bridge Card Cable
l
(1) Redundant Signal Cable
l
(1) Bypass Switch Contact Cable
l
(1) Input-Output Wire
l
(2) Blue Terminating Plugs
l
(2) Two-screw brackets
l
(2) Ferrite Cores
2. Use a 7 mm socket to remove the two screws in the middle of the two frame crossbars. Locate the
battery chassis support brackets in the installation kit, position brackets over the crossbar mounting screw
holes, and reinstall the screws (see Figure 8).
Figure 8. Install Battery Chassis Brackets on Crossbars
Note: Lifting the BladeUPS module chassis is a two-person job.
3. For the first BladeUPS module. With one man on each side, use the handled cardboard frame to lift the
module out of the box and set it on a stable surface (see Figure 9).
4. Use a Phillips screwdriver to remove the screw that secures the EM.
5. Set the EM on a stable surface.
6. Carry the first BladeUPS module to the cabinet and insert it into the bottom bay of the cabinet.
Bracket Chassis Support Brackets
Shelf EM Stop Bracket