Eaton 93E 30EBC, Руководство по установке

Страница: 27 / 60

Eaton 93E External Battery Cabinet Installation Manual P-164000057—Rev 05 19
33..55 IInnssppeeccttiinngg aanndd U Unnppaacckkiinngg tthhee EEB BC C
The cabinet is shipped bolted to a wooden pallet (30EBC) or a wooden and metal pallet (60EBC) and covered
with outer protective packaging material (see
Figure 10 ).
NOTE Startup and operational checks must be performed by an authorized Eaton Customer
Service Engineer, or the warranty terms specified on the product's resources page
become void. See
Chapter 8 Warranty for details. This service is offered as part of the
sales contract for the UPS. Contact an Eaton service representative in advance (a
minimum two-week notice is required) to reserve a preferred startup date.
WARNING
The EBC is heavy (see Table 1 ). If unpacking and unloading instructions are not closely followed, the cabinet
may tip and cause serious injury.
1. Carefully inspect the outer packaging for evidence of damage during transit.
CAUTION
Do not install a damaged cabinet. Report any damage to the carrier and contact an Eaton service representative
immediately.
NOTE For the following step, verify that the forklift or pallet jack is rated to handle the weight
of the cabinet (see
Table 3-1 for cabinet weight).
2. Use a forklift or pallet jack to move the packaged cabinet to the installation site, or as close as possible,
before unpacking. If possible, move the cabinet using the pallet. Insert the forklift or pallet jack forks
between the supports on the bottom of the pallet (see or ) for the EBC cabinet center of gravity
measurements).
CAUTION
Do not tilt the UPS cabinets more than 10° from vertical or the cabinets may tip over.
3. Set the pallet on a firm, level surface, allowing a minimum clearance of 3m (10 ft) on each side for
removing the cabinet from the pallet.
4. Remove the protective packaging material from the cabinet and recycle in a responsible manner. Retain
the parts kit box packed at the top of the cabinet.
5. Inspect the contents for any evidence of physical damage, and compare each item with the Bill of Lading.
If damage has occurred or shortages are evident, contact an Eaton service representative immediately to
determine the extent of the damage and its impact on further installation.
NOTE While waiting for installation, protect the unpacked cabinet from moisture, dust, and
other harmful contaminants. Failure to store and protect the EBC properly may void your
warranty.
Installation Plan and Unpacking