10 |
Page
01/03/2021
AUG_Eaton-3SMini_V0
4.5.
Voltage setup
Before entering voltage setup, ensure that the protected equipment is
disconnected from the UPS:
Figure 4 Disconnect the equipment
Then enter voltage setup mode and select the appropriate output DC voltage
corresponding to equipment nominal input voltage (9V, 12, 15V or 19V):
•
Press the ON/OFF button (5) for eight seconds
Important: The LED and UPS will briefly shut down (OFF to 0V) during the
process and it will turn off any connected equipment, just keep pressing the
button until eight seconds have passed. When LED start flashing (slow), release
the button.
