Page 3
Eaton-Williams
Document 0412124
Issue 2.1 05/06
QLC/ICU
Low Temperature DX Cassette
Installation & Safety
The units making up the Air Conditioning System must only be installed by a qualified engineer, following the mandatory and local codes
of practice.
Handling
Care must be taken when the units are moved or lifted to ensure that everyone and everything is safe. When lifting equipment is used
it must be suitable and approved.
Application
Ensure that the unit is only used for suitable purpose/applications.
Electrical Connection
Electrical work and connections must be made only by authorised electricians in accordance with mandatory regulations and local codes
of practice.
Warranty
Failure to comply with the manufacturer’s installation instructions could affect the performance of the unit and invalidate the warranty.
Warranty is also subject to the implementation of a planned service/maintenance agreement as documented in the warranty booklet
supplied with the unit.
Safety Procedures
General
1. All works must be carried out in accordance with the manufacturer’s installation and operating procedures.
2. Good working practices must be followed at all times so that Mechanical and Electrical hazards are kept to a minimum.
3. The equipment has been fitted with doors and covers to prevent access during operation. These must be kept in place and additional
guards fitted if necessary.
4. The equipment must be connected to an external electrical isolator if one is not supplied fitted to the unit.
5. Servicing and maintenance must only be carried out by fully qualified and competent staff. Before any work is started, electrically
isolate the units to make sure that they can not be switched on accidentally and allow sufficient time for isolated parts to come to
rest before removing panels. Electrical isolation switches must be labelled to show that they are OFF during servicing and
maintenance operations.
Note
Some units are dormant in standby mode and can restart without warning if they are not
electrically isolated.
6. Care must be taken not to touch components or pipework which may be extremely hot, or cold for a period after the unit is
electrically isolated.
7. After completing any tasks ensure all guards, covers and doors are correctly refitted before restoring the power supply to the unit.
8. Air conditioning equipment may generate unacceptable noise levels. If noise levels are unacceptable sound and vibration
attenuators may be required. For noise levels guidance refer to technical literature, or contact Qualitair, or their distributors for
advice.
SPECIAL NOTES
IF ANYTHING IS NOT CLEAR PLEASE CONTACT YOUR DISTRIBUTOR FOR CLARIFICATION.
