EasyWay N3458A, Руководство пользователя

Страница: 4 / 7

OPENING THE PACKING BOX
When you open the box, take out the protective pads, then take out the whole
scooter. Then press and hold the remote switch.The remote control button
control flow is: Press
①
first and then
②
second , press and hold
④
for floding
，
or press and hold
③
is for unfolding.
FRONT HEAD ADJUSTMENT
The fasteners on the side of the front of the scooter can be loosened up and
down according to user’s self-height.(Figure 5).
CHARGING YOUR BATTERIES
Charging is important to the batteries, and the off-board charger provided by
us can simply and quickly charge the batteries of this mobility scooter.
WARNING!You must charge your scooter’s battery with the
supplied off-board battery charger. Do not use an automotive-
type battery charger.
CHARGING YOUR BATTERIES WITH THE OFF-BOARD CHARGER:
•Make sure the scooter is power off.
•Plug the output connector of the off-board charger into the 3-pin charger
power receptacle.(see fig.3)
•Plug the input connector of the off-board charger into the electrical wall
outlet.(220V)
•The red light on the charger turns on that indicates charging on.
•When charging is nearly finished, the green light turns on. You should
continue to charge the batteries for 1 to 2 hours.
•It’s suggested to charge the batteries for 6 to 8 hours.
•Please unplug the power cord and charger when the battery is fully charged.
NEW BATTERY’S USAGE
To break-in new batteries for maximum efficiency, please follow the notes
here below:
1. Fully charge any new battery prior to its initial use. This brings the battery
up to about 90% of its peak performance level;
2. After 4 to 5 times of charging cycles, the battery will top off at 100% charge
and last for an extended period.
3. If the battery of your scooter needs to be replaced, please purchase the
battery of below specification:
Type Deep-cycle sealed lithium battery
Size 218*166*59mm
Voltage 24V
Capacity 10AH
fig.3
The battery could be charged off the scooter.
5 6
III. ASSEMBLY III. ASSEMBLY
WARNING! Please pull out the key before adjust the scooter.
Never adjust it during driving.
fig.5
① ② ③
FOLDING WITH BUTTON SWITCH
①
Standby power port
②
Power switch(“I” means power on,
”O” means power-off protection, “II”
means standby power); Press the power
switch to “O” when the mobility
scooter is in idle, especially for long
time.
③
Folding button(“I” means unfolding,
“II” means folding)
Note:If the scooter can’t be unfolded when the battery is depleted ,
connect the charger to standby power port, and press the power
switch to “II” , then the scooter could be unfolded.
①
②
③
④
①Unlock Button
②Initiate Button
③Unfolding Button
④Folding Button