UV Installation and Maintenance
WARNING: Disconnect the unit from power source before performing any maintenance or installation
on the unit.
USE A CLEAN CLOTH TO HANDLE THE UV LAMP, TOUCHING THE LAMP CAN GREATLY REDUCE ITS LIFE
Instructions for replacing and cleaning UV lamp and quartz sleeve. Periodic cleaning of the quartz sleeve may
be necessary for the UV light to reach the bacteria. If the UV lamp is functional and intact, the sleeve may be
replaced or cleaned with a soft cloth and reassembled. After a year of continuous use the lamp may still light
but the UV effectiveness is diminished.
3. Unscrew and remove the large
threaded cap on the UV housing to
reveal inner UV assembly.
6. Remove grommet from end of the
lamp and set aside, gently pull lamp
out of the socket and discard.
9. Reinsert UV assembly into plastic
housing, tighten cap and replace
everything back into base.
1. Unscrew fountain assembly, then
remove top cover from unit.
5. To replace lamp, unscrew threaded
ring that holds the quartz sleeve in,
and remove sleeve from UV assembly.
7. Using a clean soft cloth remove the
new lamp from its package and gently
push the lamp into the socket. Do
not touch the UV lamp with your
fingers.
2. Remove three Phillips screws on
pump, pull pump out of base and set
aside.
4. If the UV lamp is functional and intact,
sleeve may be replaced or cleaned
with a soft cloth and reassembled.
8. Replace grommet to the end of the
lamp and reinsert into quartz sleeve.
