5
Rev. 1.1 03/12/10
F
OR THE
U
SER
-
I
MPORTANT
- The device should not be used by children or by individuals
with reduced physical or psychological abilities unless supervi-
sion is provided or instruction given on how to operate it.
- Do not let children play with the device; keep radio controls
out of their reach.
- CAUTION: Keep this instruction manual in a safe place and
observe the important safety instructions contained within it.
Non-observance of these instructions may lead to property
damage and serious accidents.
- Examine the system frequently to check for any signs of
damage. Do not use the device if it needs to be repaired.
- We recommend carrying out the opening and closing opera-
tions of the blind or rolling window shutter in visible conditions,
ensuring no persons are in a dangerous condition during
movement.
Warning
All procedures which require the casing to be opened (such as
wire connection, programming, etc.) must be carried out during
installation, by skilled staff only. For any other procedure which
requires the casing to be opened again (re-programming, re-
pairs or site modifications), please contact the technical assis-
tance service.
The below products:
LG2214 SWR – LRS2214 SWR –
LRS2214 SWR SET – LRH2214 SWR
conform to the specifications in the Directives R&TTE
99/5/EC, EMC 2004/108/EC, LVD 2006/95/EC.
F
OR THE
I
NSTALLER
-
I
MPORTANT
- The control unit was designed to enable the installer to
automate sun blinds and rolling window shutters adhering to
the provisions set out by current legislation. Compliance with
these obligations and the implementation of the minimum
safety requirements is the responsibility of the installer.
We recommend installation is performed in full compliance
with EN 60335-2-97 (“Household electrical appliances and
similar - Safety”, part 2 “Particular requirements for drives for
rolling shutters, awnings, blinds and similar equipment).
In this regard, realise the plant combined with this components
control unit (motor, mechanical parts, etc.) resulting conform in
satisfying the necessary safety requisites.
- The control unit must be permanently connected to the
power supply network and is not equipped with any type of
230 V a/c electric line sectioning device. The installer is re-
sponsible for installing a sectioning device in the system. An
omnipolar switch with overheating category III must be in-
stalled. It must be positioned in such a way that it is protected
against accidental closures.
- For connections (power supply and motor output) we rec-
ommend the use of flexible wires with an insulating sheath in
harmonised polychloroprene (H05RN-F). The wires should
have a minimum cross-section of 0.75 mm
2
.
- Fasten the connection cables using the cable clamp sup-
plied with the product kit.
- In choosing the motor to combine with the control unit, keep
to the maximum power indications contained in this manual.
−
For the radio receiver to operate correctly when two or more
control units are used, we recommend that you install the
devices at least 3 metres away from each other.
−
If two or more control units are installed, we recommend
only one Wireless Sensor is used in order to avoid radio in-
terference.
