Installation and user guide for the EEN-REC3-RW receiver
Page 2 / 6
V233 – 0012 – AA
Cabling diagram:
Instructions to follow:
The receiver must not be enclosed in a metal case or placed behind a protective area that uses
wire netting. In the event that you cannot do otherwise, you must connect the 868 MHz aerial
that you will install outside.
To achieve satisfactory operation, there must be no metal obstacles between the active aerial and
the normal position used for operating the remote controls. It is therefore preferable to install the
receiver in a high location to avoid obstacles (e.g. wire netting).
Drill the holes as accurately as possible in the cable grommets to prevent any water seeping into
the receiver. Failure to comply with this requirement will void the warranty.
C
T
Voltage-free
contact
to
the
device
to controlon
entry
C
T
Voltage-free
contact
to
device
to control
on exit
-
+
POWER
T1
C1
2 Relays
T2
C2
2
1
ANT.
Power supply
12
24 V AC/DC 100mA
2
1
ANT.
With 868 MHz aerial
(NOT SUPPLIED)
With the wire
(Factory fitted)
Core
Woven
2 1A 24V Relays.