http://www.easy2access.net
Easy2Access A/S
®
Easy-903 G2 Pin Code lock
23
Resetting the lock
Resetting the lock can only be performed by an authorized installer. It is
therefore of utmost importance that you remember your master codes, which
can add and delete all codes. Should you have forgotten the codes please
contact
Easy2Access A/S
in Denmark at
0045-70237032
.
8.
Locking of a multipoint mortise
If you are in possession of a lock with multi point mortise, the method for
activating all locking mechanisms is the following:
1.
Leave the house and close the door
2.
Unlock the door with any of your codes.
3.
Lift the handle up.
All locks are activated.
9.
Generation of a ”key” /pin code far away from the lock
Locks marked by Easy-903 G2 (written on the battery cover) has an extra
feature: With this lock it is possible to generate ”keys”/pin codes, far away from
the lock. The possibility is only available if the lock is subscribed at Easy2Access
A/S homepage. There are two types of codes: one time codes, which can only be
used once and multi-times codes, which can be used until a new code is
generated from the Internet.
10.
Maintaining the Lock
The outside body of the lock should at least once annually be polished with
WD40. WD40 ensures the lock is cleaned for dirt and is protecting for corrosion.
If the lock is exposed to sea fog or salt in other ways, it is recommended to
polish after each exposure. The lock will corrode if exposed to salt and not
protected with grease.
11.
Changing batteries
When the voltage is lower than
3.3V, then the lock will start to send an
alarm,
which means the batteries must be changed. You will hear 8 beeps and see the
red lamp is activated.
The PIN-codes in the lock will be remembered in the lock during change of
batteries.
