Easy HC10, Руководство пользователя, Страница: 10 / 15

easy-HC10 User Manual Rev 2.2 Page 10
5
INSTRUCTIONS
a) FUNCTION OVERVIEW
To release reservoir:
•
Press the button on the off side of the product and gently pull down on the reservoir to
release it for cleaning or refilling.
To install reservoir:
•
Place reservoir on flat surface and then slide the sprayer down onto the top of the
reservoir pushing down firmly until you hear a click form the reservoir lock button.
To remove the battery:
•
Press down the big grey button on the back of the battery and pull away from the sprayer
firmly.
To install the battery:
•
Line up the battery to the back of the sprayer and push firmly inwards towards the
handle until a click is heard and the battery is secured.
•
To check the battery is in properly perform a quick press of the trigger, this will cause
the membrane keypad to light up if the battery is installed correctly.
Membrane keypad usage:
•
The three different disinfectant strengths are selectable by using the orange button to
cycle through them, a blue LED will be lit when a specific strength is selected. 45 ppm
is for food surfaces and sensitive areas. 100 ppm is for everyday disinfecting and
cleaning. 150 ppm for deep cleans. If no lamps are illuminated the electrochemical
reactor will be OFF and therefore inactive.
•
The battery icon displays the battery level using 3 green LEDs. If all 3 are lit the battery
is fully charged. If 1 LED is lit the battery needs to be charged.
Trigger usage
•
Press and hold the trigger for the sprayer to function. The sprayer has an orange button
next to the trigger that will lock the sprayer on if pressed when the trigger is fully
engaged. This is to make large-area disinfecting easier and efficient. To disengage the
trigger lock firmly press the trigger down and the lock button will click out and the
sprayer will turn off.
•
A quick press of the trigger will engage the membrane keypad for battery level check
and pre-spray disinfectant strength selection.