Easy-Laser XT11, Руководство пользователя

Страница: 35 / 81

Rough align
When making a new installation, a rough alignment can be necessary. Place the Measuring units on the rods, make
sure they are at the approximately same rotational angle and radius. Also make sure that the adjustment knob is
adjustable in both directions.
1. Place the Measuring units at 9 o’clock. Adjust the laser
line to the center of both targets. Use the adjustment
knob and/or move the detectors on the rods.
2. Turn the shafts 180º. Make a mark on the rods or
machine halfway between the laser line and center of
both targets.
3. Adjust the laser beams half way to the center of tar-
gets. Use the adjustment knobs and/or move the
detectors on the rods.
4. Adjust the movable machine until the laser beam hits
the center of both targets.
5. Turn the shafts 180º. Check if both laser lines hit the
targets. If not, repeat step 3–5.
Turn shafts to 12 o’clock. Repeat all steps for vertical
adjustment.
35
HORIZONTAL