SET UP
Remove all items from the box.
Compare with list below to
make sure unit is complete.
(2)
Arbor Nut [1]
(4)
Flange [2]
(2)
Spacer (short) [3]
(2)
Spacer (long, 1HP only) [4]
End Caps [5]
Label [6]
Power Switch [7]
Base [8]
Motor Housing [9]
NOTE: Buffing wheels sold separately (see page 7)
MOUNTING
Eastwood buff motors are quite heavy. Make sure the workbench on which you plan to use can hold the
weight of the motor and the added loading when the buffer is in use. The workbench should have a level
surface and be heavy, or attached to the floor, so it will not move during operation.
TO MOUNT THE BUFFER
1. Pick a spot on the workbench that will allow enough room to move the size of an anticipated
workpiece around the buffer. The operator should have enough room to move out of the way in
case of an emergency.
2. Mount the buffer to the pedestal or workbench with bolts that are long enough to exceed the
thickness of your mounting surface and the buffer base. Secure these bolts with flat washers,
a lock washer and a hex nut. This hardware is NOT included because the size of bolts and
hardware that are needed for this step will vary depending on your application.
3. Mount the buffer in an area with proper lighting and near electrical outlets. Lighting should
be bright enough to eliminate shadow and prevent eye strain. Electrical circuits should be
dedicated or large enough to handle amperage requirements. Keep power or extension cords
clear of high-traffic areas. Observe local electrical codes for proper installation of new lighting,
outlets, or circuits.
9
6
5
7
8
1
2
3
4
To order parts and supplies: 800.343.9353 >> eastwood.com
5
