© Copyright 2018 Easthill Group, Inc. 7/18 Instruction item #32405Q Rev 1
If you have any questions about the use of this product, please contact
The Eastwood Technical Assistance Service Department: 800.343.9353 >> email: [email protected]
PDF version of this manual is available at eastwood.com
The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA 800.343.9353 eastwood.com
OPERATION
• Grip the lamp housing press the Latch Button and rotate
Magnetic Base through 360° in the vertical and 110° hori-
zontally on the Swivel Ball
(FIG 2)
.
• Place the base against any ferrous metal surface for mag-
netic attachment.
• Release Retractable Hook to hang from overhead objects.
• Depress and release round Button located at side of Housing
once for Low Brightness and a 2nd time for High
(FIG 1)
.
• Depress Button once again to turn off.
Batteries will slowly discharge without use and must be charged every
3 months even if the light has not been used.
Do Not charge batteries in temperatures below 40°F [4.4°C].
CHARGING WHILE IN USE
The Lamp will default to the Low power setting while charging. The required charge time will be
extended if the lamp is operated when charging.
CHARGING
• When the LED power indictor
(FIG 1)
located at the side of
the Housing glows RED, the battery requires charging.
- Flip up rubber seal and plug the Micro USB terminal
of the included Adapter Cord into the Micro USB port
(Fig 3)
.
- Plug the opposite USB end into the USB port of the
included Wall Charger or any suitable USB port
(Fig 3)
.
- Plug wall unit into properly grounded 120 VAC,
60 Hz. outlet.
- Allow 4 hours for full charge.
- The indicator LED at the side of the Housing will illuminate RED while charging then
illuminate GREEN to indicate full charge
(Fig 1)
.
- Close Charging Port Cover to maintain IP-65 rating.
FIG. 2
FIG. 3