Eastwood 31490, Инструкция по эксплуатации, Страница: 6 / 8

6
Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com
• With your helper lifting the opposite side, carefully place the Tool Chest between the four Vertical Posts [D] and on the ledges of the Cross Supports [E] .
IMPORTANT NOTE: The upper edge of the Tool Chest is crimped over and designed to fit over the upper edges of the Vertical Posts [D] (FIG 3) .
• Once the Tool Chest is properly located, attach with M8 x 12mm Carriage Head Bolts
[H]
, M8 Flat Washers
[M]
and M8 Nylon Insert Locknuts
[L]
.
IMPORTANT NOTE
: At this point decide which end you wish the handle to be located and add hardware to the two UPPER end holes only
(FIG 3)
leaving the lower two open.
• Lastly, locate the Handle [G] over the two lower end holes and attach with the two longer 16mm Carriage Head Bolts [J] , M8 Flat Washers [L]
and M8 Nylon Insert Locknuts [M] . Tighten securely.
• Your Eastwood Rolling Tool Cart is now ready for use.
FIG. 3
✓
✓
✓
H
F
D
J
G
Fit crimp over edge
✓