Eastwood 30551, Инструкция по эксплуатации, Страница: 6 / 9

SET-UP
NOTE: Eastwood Hydraulic Wheel Dollies may
need to be purged of air before the fi rst use.
1. Turn the Release Valve knob in a counter-
clockwise direction (when viewed from above)
to open
(Fig A) and remove Lock Pin.
2. Carefully grasp each roller and slowly push
them apart to the fully open position.
CAUTION: Do not allow rollers to move
inward with Release Valve open.
3. Slightly depress the Foot Pedal and carefully
release the Foot Pedal Lock.
CAUTION: The
Foot Pedal is under spring tension and will
quickly rise up when the Foot Pedal Lock is
released.
4. Slowly operate the Foot Pedal through 5 to 10
full strokes.
5. Close Release Valve fully by rotating in a
clockwise direction.
6. The Eastwood Hydraulic Wheel Dollies are
ready for use.
OPERATION
NOTE: Best results are achieved with the use of
four (4) Eastwood Hydraulic Wheel Dollies.
LIFTING VEHICLE
1. With the Rollers spread apart, roll the
Hydraulic Wheel Dolly in place with each of
the Rollers positioned at tire tread, ahead of
and behind the wheel
(Fig B) . CAUTION: Do not allow tire sidewall to come in contact with any part of the Hydraulic
Wheel Dolly frame and allow a minimum of 1" (25mm) between sidewall and frame to accommodate tire fl ex under
load.
2. Be sure the Release Valve is securely closed.
3. Depress the Foot Pedal repeatedly until Rollers begin to apply pressure to tire. Check for tire sidewall to Wheel Dolly
frame contact.
4. Continue to depress Foot Pedal until tire tread is lifted from the fl oor.
5. Engage the Foot Pedal Lock and place the Lock Pin in the nearest open retaining hole to lock the jack in the raised
position (Fig B).
6. Repeat for remaining Wheel Dollies.
7. Push the vehicle to the desired location.
LOWERING VEHICLE
1. Depress the Foot Pedal slightly to release the Foot Pedal Lock.
2. Remove the Lock Pin. (The Foot Pedal may need to be pumped slightly to release pressure on the Lock Pin).
3. Slowly turn the Release Valve knob in a counter-clockwise direction (when viewed from above) to open.
4. Vehicle weight will spread the Rollers apart and allow vehicle to lower until the tire tread contacts the fl oor.
5. Pull Dolly away from wheel.
6. Replace Foot Pedal Lock to keep Foot Pedal in place.
Fig. A
Hydrauli
c
Ra
m
Releas
e
Valv
e
Foot
Pedal
Lock
Roller
s
Foot
Pedal
Fig. B
Hydrauli
c
Ra
m
Hydraulic
Oil
Plug
Lock
Pin