2
Eastwood Technical Assistance: 800.544.5118 >> [email protected]
To order parts and supplies: 800.345.1178 >> eastwood.com
7
READ INSTRUCTIONS!
Thoroughly read and understand manual before using this Rotary Removal Tool.
Save for future reference.
SAFETY INFORMATION
OPERATIONAL HAZARDS!
•
Wear approved eye gear at all times when operating the tool for protection from possible
ejected particles, shards and sparks created from cleaning, sanding or grinding.
•
This tool can generate a trail of sparks which are ejected at high speed.
Keep pets, people and flammable materials out of the path of the spark trail.
•
Keep loose clothing, jewelry and long hair away from rotating components
as serious personal injury can occur.
•
ALWAYS
disconnect tool from air supply when changing wheels to prevent
accidental tool starting and potential injury.
•
WARNING
This tool is very powerful and generates a great deal of torque while
operating. Always handle with two hands and exercise great caution while
operating.
•
Do not force tool while cleaning or grinding as the tool body can suddenly kick
back or twist causing severe hand or wrist injury. Cleaning wheels can also be
damaged by excessive side force causing them to disintegrate and eject pieces at
high velocity.
•
ONLY USE
replacement wheels rated for 3500 RPM or greater use otherwise
serious injury or death can result in the event of wheel failure.
•
NEVER
attempt to operate without guard in place or serious injury can result.
•
Always make sure the work piece being cleaned/sanded is securely clamped or
anchored to allow two-handed operation of the tool.
• Repetitive motion and extended exposure to vibration may harm hands and arms.
WARNING!
DO NOT
exceed
90 psi [6.3 bar]
of tool inlet air pressure. Permanent tool damage
and or personal injury could occur.
ATTACH 4" ADHESIVE ERASER WHEEL
• Disconnect air supply from the tool to
prevent accidental starting and potential
injury while installing or removing wire,
sanding or cleaning wheels.
• Place the 4" Adhesive Eraser Wheel
Assembly with the Hex Drive Recess over
the Hex Drive Spindle. (
Fig E
)
.
• Insert the Socket Head Cap Screw into the
center hole of the Eraser Wheel Hub (
Fig I
)
and tighten securely with the included
5mm Hex Key.
Fig. I
Fig. E
MAINTENANCE
• Add several drops of air tool oil before each use by dropping directly into the air inlet.
• If tool is to be unused for an extended period, add 10 drops of air tool oil directly to the air inlet,
rotate the tool motor by hand several times to distribute the oil throughout the motor and
gearbox then store the tool, handle up.
• With the air supply disconnected, periodically check that the Socket Head and Wheel Retaining
screw is tight.
