© Copyright 2020 Eastwood Automotive Group LLC 1/20 Instruction item #21980Q Rev 1
If you have any questions about the use of this product, please contact
The Eastwood Technical Assistance Service Department: 800.343.9353 >> email: [email protected]
PDF version of this manual is available at eastwood.com
The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA 800.343.9353 eastwood.com
PROBLEM
CAUSE
CORRECTION
Finish Surface
of Workpiece
is Rough
Improper blade break-in
Follow proper blade break-in procedure.
Improper speed or feed rate
Adjust as needed.
Dull or damaged teeth
Replace blade.
Poor weld on blade
Replace blade or reweld blade.
Incorrect choice of blade
Check Machinery’s Handbook for recommended blade type.
Miter Cuts Are
Not Accurate
Improper setting of Material Clamp
Use adjustable square or protractor to verify angle setting.
Blade worn, not cutting straight
Replace blade.
Blade Twisting
Cut is binding blade
Decrease feed pressure.
Too much blade tension.
Decrease blade tension.
Motor
Overheats
Excessive pressure being applied
while cutting
Reduce load on motor. Increase speed or decrease feed pressure.
Air circulation through motor is
restricted
Use a brush and compressed air to remove debris.
Sporadic or No
Coolant Flow
Low coolant level
Add coolant to tank.
Filter screen clogged
Clean filter screen.
Pump motor faulty
Replace pump.
TROUBLESHOOTING
