To order parts and supplies: 800.345.1178 >> eastwood.com
3
SET UP
1.
Place the Shear on a clean, level surface at a comfortable working height.
Mount securely to the work surface using 2 suitable lag screws or bolts (not
included) through the two holes in the steel base
(FIG 1)
.
2.
Using two 13mm wrenches, remove the Nut and Washer from the Upper
Cutting Die. Slide Handle over the Upper Cutting Die Bolt and ensure that
the Pawl can engage the Gear. Re-install Nut and Washer.
CUT LAYOUT
For best accuracy it is recommended that you coat the cut area with layout fluid
or a marker and then scribe your cut line rather than using a marker
(FIG 2)
. The
width of the scribe line will be much smaller and will provide a precise guide when
compared to the wide marker line.
OPERATION
1.
Apply moderate pressure to push the metal into the cutting dies as you pull
the handle towards you
(FIG 3)
.
2.
To ratchet the handle simply rotate the handle away from you. Gravity will re-
engage the pawl on the upper cutting die when you pull it towards you to cut.
3.
To make a curved cut, rotate the metal while it is fed into the dies.
NOTE:
The mini rotary metal shear creates its trim, the unwanted cut piece,
on the right. When cutting a curve make sure the unwanted portion is to the
right of the upper die
(FIG 4)
.
NOTE:
The Cutting Dies have been adjusted by the factory for optimal cutting
performance. Do not attempt to adjust dies as improper overlap can cause
reduced performance and Cutting Die failure.
STORAGE
• Lower the Handle to ensure that it cannot engage the Upper Cutting Die
in storage.
• Apply a thin film of light oil or rust-preventive coating to all bare steel areas.
• Store in a clean, dust-free, dry, dampness free area preferably covered with
plastic sheeting.
Always keep the handle in the lowest possible position
when not cutting. The weight of the handle can cause
the upper die to suddenly and unexpectedly rotate.
FIG. 1
The cutting dies are extremely sharp! Use extreme care
when operating to avoid severe cuts or loss of fingers!
The cutting dies are extremely sharp! Use extreme care
when operating to avoid severe cuts or loss of fingers!
FIG. 2
FIG. 3
FIG. 4
