Eastwood 20198, Инструкции

Страница: 3 / 4

To order parts and supplies: 800.345.1178 >> eastwood.com
3
ASSEMBLY & MOUNTING
Mounting
1. This Shear is designed to be bolted to a solid metal or wood surface.
2. Position the Shear onto the surface it will be mounted to in the preferred orientation.
Check overhead clearance for handle. A minimum of 48" is recommended. Check below
mounting surface for obstructions like electrical wires, or brackets.
3. Mark the center of each of the mounting holes onto the mounting surface.
4. Move the Shear Aside and drill through the surface at each of the points.
5. Position the shear back over the holes.
6. Install high grade bolts with washers (not included) that are the proper length to go through
the base of the shear and the mounting surface. Do not use lag screws!
7. Install fl at washers and nuts onto the bolt on the bottom side of the mounting surface
and tighten securely.
Assembly
1. Lubricate all moving parts of the shear with heavy oil.
2. Install the two M10x1.5 Hex Bolts with Washers through the Handle and into the Shear Handle
Mount using a 17mm Wrench.
OPERATION
Cutting Flat Material
1. Insert material into rear of jaws.
2. Adjust material hold down, if utilizing, by threading out to hold material in place.
3. Pull down on handle to begin the cut. If cutting a piece longer than the blade length, do not
pull the handle all the way down. Pull partially and then lift up on the handle and slide the
piece forward to keep the cut in line with the jaws.
Cutting Round Material
1. Insert round material into the hole in the side of the upper jaw which is designated for
cutting round material.
2. Pull down on handle to cut.
MAINTENANCE
1. Before each use lubricate all moving and bare steel parts with heavy oil to keep the shear
functioning smooth and avoid corrosion.
2. Check the handle and base mounting bolts to ensure they are tight.