6
Eastwood Technical Assistance: 800.343.9353 >> [email protected]
SOCKET OR ACCESSORY INSTALLATION
• Snap the desired impact socket or accessory onto the 1/2” square drive.
This Impact Wrench can quickly start up when handling while plugged in to electri-
cal supply causing serious personal injury. Always unplug the tool from the electrical
supply before changing sockets, accessories or performing maintenance.
Use with sockets and accessories designed and rated for impact use only.
DO NOT attempt to use on non-impact rated sockets and accessories.
Sharp metal fastener edges can cut. Always wear protective gloves while handling.
OPERATION
• While holding the Impact Wrench securely in two hands, depress
the Trigger located at the forward surface of the Impact Wrench
body handle
(FIG 1)
.
• Pressing the lower “R” indicated portion of the Trigger will
LOOSEN fasteners.
• Pressing the upper “F” indicated portion of the Trigger will
TIGHTEN fasteners.
• To begin Impact Wrench operation, allow several seconds for the
motor to reach full torque, then continue to hold the Trigger until
the fastener loosens.
• Slowly and steadily allow the rotating drive to do the work.
• When the fastener has been loosened, release trigger and allow the Impact Wrench to stop rotating
before pulling the socket away from the fastener.
Always operate the Impact Wrench with two hands. Failure to do so could cause
serious personal injury.
The Impact Wrench features a convenient power supply indicator located at the top
rear of the housing which illuminates amber whenever the power cord is plugged in.
DO NOT force the Impact Wrench forward or kickback could quickly occur causing
severe injury!
FIG. 1