OUTDOOR USE ONLY / NEVER LEAVE UNATTENDED
Page 6 of 19
Fig. 12
Fig. 13
Use supplied wrench to make sure all nuts and bolts are tight before proceeding to the next section.
Step 1.3 Fuel Safety
Only use LP gas with this appliance.
Only use an approved 20 lb. LP gas tank with this appliance (same as those commonly used on gas grill with
Acme/Type 1/QCC1 Safety Valves). These can be quickly identified because valves have external threads.
LP gas is flammable, explosive under pressure, colorless, tasteless and heavier than air. It pools in low areas.
LP gas is naturally odorless, but a distinctive odor has been added by the LP gas supplier for your protection.
LP gas can cause skin to freeze on contact.
Burning LP gas consumes oxygen and produces carbon monoxide, a deadly gas. Never operate this
appliance inside a building or confined area.
Carefully read and follow all instructions on LP tank.
The LP-gas supply tank must be constructed and marked in accordance with the specifications for LP-gas
tanks of the U.S. Department of Transportation (DOT) CFR49 or the National Standard of Canada,
CAN/CSA-
B339, Cylinders, Spheres and Tubes for the Transportation of Dangerous Goods.
Never use a LP tank with a damaged body, valve, collar or foot ring. A dented or rusty LP tank may be
hazardous and should be checked out by a LP gas supplier.
Use only LP tanks that include a collar to protect the tank valve.
Do not store spare LP gas tanks under or near this appliance. Never fill the tank beyond 80 percent full. If
these instructions are not followed exactly, a fire causing death or serious injury may occur.
When appliance is not in use, gas must be turned off at the supply cylinder. Storage of the appliance indoors
is permissible only if the cylinder is disconnected and removed from the appliance. Always use and store LP
tank in an upright position. Never store or transport LP tank in occupied enclosures. LP tanks must be stored
outdoors out of reach of children and must not be stored in a building, garage or any other enclosed area.
Always perform a leak test on all gas connections whenever a tank is connected. If bubbles form in the leak
test solution, do not use. Never use a flame to test for leaks.
Step 1.4 Connecting the LP Gas Tank
See figure 14 for the regulator control valve on
right and the timer shutoff on the left. See figure
15 for the QCC1 fitting.
Fig. 14
Fig. 15
NOTE:
The regulator control valve controls the flame intensity and acts as an On/Off valve when operating the
appliance. When finished cooking or in case of emergency, close the LP tank valve by turning LP tank valve
clockwise until tight (Closed Position). Be sure to close LP tank valve before disconnecting the hose.
Clean and Inspect hose before each use. If evidence of abrasion, wear, cuts,
or leaks, replace hose prior to operation. Replace only with Eastman
Outdoors high pressure regulator hose assembly Model S90099.
High pressure regulator hose assembly supplied must be used. Do not use
high pressure regulator hose assembly with any other gas appliance.
Failure to follow these instructions can lead to fire or explosion, which
could cause property damage, serious personal injury or death.
