Internet Speed:
1. Go to the location where the Video Doorbell will be installed.
2. Connect to the 2.4 GHz WiFi network.
3. Run an
Internet speed test
to determine the Internet speed.
4. In the test results, note the Upload speed. The Video Doorbell requires an
upload speed of at least 2 Mbps.
Hardware Install:
1. Remove existing doorbell – ensure the wires don’t slip into the wall.
2. Attach doorbell mounting bracket to the wall.
a. Feed the wires through the hole in the centre of the bracket.
b. Mount the bracket frmly with the wall screws (provided) through the top &
bottom holes in the bracket.
c. Failure to make the bracket fush on the wall could cause a poor power connection.
3. Connect power wires to the mounting bracket.
a. Loosen terminal screws and insert wires beneath the screws – be careful not to
touch the wires together during this process.
b. Tighten the screws so the screw heads are fush with the bracket.
c. The wires must be approximately equal thickness.
4. Attach the Video Doorbell to the mounting bracket.
a. Slide the Video Doorbell down on to the mounting bracket and push the front
toward the wall.
b. Tighten the set screw located on the bottom of the camera (be careful not to
damage it – do not use a power tool for this step).
c. The camera’s LED light should light up.
5. Syncing with Alarm.com
a. The Video Doorbell is ready to sync when the LED light is alternating red & green – this
means it is ready to use AP mode.
Reference the “How to Set up the Camera” section on page 6 to fnish seting up the camera.
5
