Eastey Perfomance EN Series, Руководство пользователя

Страница: 17 / 40

Operation 17
product and film into the sealing area. Do not place product in the first few bags formed
by the sealer: they will not have any perforation holes in them (because the sealer and
pin perforator work together). Perforation is required to allow air to vacate when the
product passes through the shrink tunnel.
Cradle-Mount Film Unwinder
Begin inserting product into the film as soon as the film reaching the seal area has
perforations in it. Place the product against the back of the film separator tray and then
move product into the seal area. Be sure to leave the bag loose around the product
when making the seal. This helps keep the seals from blowing out in the shrink tunnel.
See Sequence of Operation, which follows, for more detailed instructions for operating
the L-sealer.
Sequence of Operation
1. Place the product on the product tray.
•
The product tray separates the film, allowing you to place the product
between the upper and lower layers of film.
2. Move the product into the seal head area, pushing it to the left.
3. Move hands out of the seal head area and pull the seal head down. Let go of the
handle as soon as the magnets activate.
•
The magnets hold the seal head down for the amount of time required to
make the seal. The amount of time is adjustable by turning the Dwell timer
knob, which is located to the left of the Power switch under the product tray,
to increase or decrease the amount of time.
Film
Roll
A-Wind
B-Wind
Support
Rollers
Pin Perf.