the mouse to enter the power saving mode
5. Nano receiver
A very small size design for Nano receiver, it can be plug and stay on USB port
of PC/Notebook without interference.
Portable design for travel, Nano receiver can be plug in the slot on bottom of
mouse
6.
Polling rate adjustable function
3 adjustable polling rate 125Hz/250Hz/500HZ, default as 125Hz
7.
Buttons: Left key, right key, middle key, CPI+,CPI-, Home ,Two side
keys
Reconnection
Both of mouse and Nano receiver has a built-in code, It can be setting one mouse
to one receiver, or few of mouse to one receiver. Mouse and receiver need to
reconnect under the condition of High temperature, high magnetic, strong vibrate.
1.
Plug off nano receiver from USB port, and plug it on
2.
Keep the mouse in 50CM with receiver, re-store the battery
3.
You can use it by reconnection
4.
FCC Statement
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions (1)this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
