Active/Passive Retro-Fit for P-Style Basses
normally a black ground wire connected to the bridge which is soldered to the jack ground, and there may be others,
depending on the age and type of instrument.
• Once the pickguard has been separated from the bass, move to a surface where it will be protected while you work
on it. Then remove the knobs, potentiometers and jack with the wiring intact. Wrap each knob individually and store
with the electronic parts for safekeeping.
• As final preparation, carefully remove the insulation, 6-7mm (1/4”), on each piece of wire, taking care not to cut or
fracture any of the internal conductors.
• CHARGE STATUS LED
An LED Bezel is supplied in order that the LED can be mounted in the scratch plate if desired, in which case a hole will
need to be drilled. It is appreciated that most will not want to make any changes to an instrument which will prevent its
return to stock condition, certainly not recommended for an instrument with any vintage value.
To mount the LED Bezel in the scratch plate,
a hole will need to be drilled very carefully
:
• A guide template is supplied as an aid, which illustrates a suitable position for the LED on the pickguard.
• Use a 6.0mm diameter drill to create the hole according to the template.
• Fit fit the LED Bezel in from the top, fit the lock washer and nut, and then tighten.
Page 6