7
Figure 2.1-5
8.
Press
and
to increase or decrease 1 of the horizontal line position (the
number will be based on automatic stepping without change of horizontal line
position); press
or
to change the position of horizontal line.
9.
Press
until the buzzer works and to enter 0mV as 0% value.
10. Likewise, press
to increase output value to be 100mV, and then press
until the buzzer works and enter 100mV as 100% value.
11. Press
or
to make output increase or decrease within the span of
0% to 100% based on 25% advance amplitude. The screen will display as shown
in Figure 2.1-6.
Figure 2.1-6
2.2 Shutdown Mode
The calibrator comes with the shutdown mode enabled for a time duration set to 30
minutes (displayed for about 2 seconds when the calibrator isinitially turned on). When
the shutdown mode is enabled, the calibrator will automatically shutdown after the
time duration has elapsed from the time the last key was pressed. To disable the
