21
INSTALLATION & OPERATING MANUAL
20
ACCURON CARTRIDGE METER
SERIES 7200
SENSOR CABLE PREPARATION
2.
Remove outer shield. Measure 1-3/8” from the end of
the cable. With a pair of small side cutters, cut the shield
around the cable at the measured point and remove the
outer shield.
VELOCITY SENSORS (PAIR)
IMPORTANT
Before pulling the sensor cables through the conduits,
mark the ends of the cables to indicate which is the
upstream and downstream sensor cable. Leave
approximately 1 foot of cable extending from the
conduit in the enclosure. Prepare the cable ends in the
following manner.
NOTE: All Drawings are to scale. They may be used as a
template.
1.
Remove outer cable cover.
Measure 1-7/8” from the end of
the cable. With a cutting tool,
carefully cut through the outer
cover making sure not to cut into
the outer shield. Remove the
outer cover.
1-3/8”
1-7/8”
Remove
Outer
Shield
Remove
Outer
Cover
1
2