E: Use long nose pliers take off the close end wire connector of kneading motor. ( As pictures below show.)
F: Slacken and remove the screws which fixing the kneading motor, then we can detach the kneading motor.
6: Guidance of change the counting sensor of rolling motor.
A: Detach the rear cover of backrest. Then we can find counting sensor of rolling motor.( Refer to
Guidance of
detach front cover & rear cover.
)
B: Use diagonal cutter get ride of the cable ties which fasten the mechanism wires.
Squeeze the close-end wire connecter.
Close-end wire connecter has been
removed.
Locate the screw.
Kneading motor has been detached.
Locate counting sensor of rolling motor.
Cable tie has been taken off.
Locate cable ties.
