17
16
Empty the water container
1.Open the maintenance cover.
2.Unscrew both locking levers towardas each other.
3.Clean the filter base completely.
4.Re-insert the filter base!
5.Screw both locking levers.
6.Close the
until it locks into position.
maintenance cover
1.Open the door.
2.Take out the filter door.
3.Clean the filter door; wipe off the scrap threads
4.Reinstall the filter door.
which will cause the extension of drying time and energy consumption;
1.The fluff accumulated on the filter will block the air circulation,
2.Do disconnect the power cord before cleaning!
3.Do not operate the dryer without the filter!
4.Clean the filter after each use to prevent lint accumulation inside the dryer.
NOTE!
Clean filter base
(Only
EMTD8HP
)
accumulated on the filter door.
1. Hold and pull out the water container
with two hands;
2. Tilt the water container, pour out the
condensed water into basin;
3. Install the
WARNING:
1.
2.Do not drink the condensed water
.
water container.
Empty the water container after each use, the programme will be paused and the Full
LED will light if the water container is full during the drying process. After the container
emptyed, the dryer can be restarted by pressing
【
Start/Pause
】
button.
3.Do not use the dryer without the water container
Clean the filter door
Clean heat exchanger
(Only
EMTD8HP
)
As necessary, approx. once every 2 months, remove the fluff from
the heat exchanger using the sponge or soft brush.
When doing this, please use gloves.
Note: The fluff can be removed more easily if it is first
dampened e. g. with a laundry dampener.
Filter door
Locking lever
Maintenance cover
Filter base
Cleaning and routine maintenance
-Leave the dryer to cool down.
-Residual water may escape, place an absorbent
cloth under the maintenance cover.
1.Clean with water only; do not use hard/sharp-edged objects!
Do not operate the dryer without the air condenser
!
Wash air condenser
(Only
EMTD8CB
)
2.During drying, water may
and the seal,
collect between the window
but this does not affect the function of your dryer!
!
1.Unlock the maintenance cover.
2.Completely open maintenace cover.
3.Screw both locking levers towardas each other.
4.Pool out the air condenser.
Do not damage the air condenser!
5.Clean the air condenser completely, drain thoroughly.
6.Clean the seals.
7.Re-insert the air condenser, handle at the button!
8.Unscrew both locking levers.
9.Cloth the maintenance flap until it locks into position.
Please clean the air condenser approx, once every 3
months if frequently used
.
Cleaning and routine maintenance
V.1
V.1
