E A R T H X J U M P P A C K
2
Operating Instructions
Failure to follow these instructions may result in damage to the device!
JUMP STARTING
1.
Select the appropriate adapter cable (12 volt or 24 volt)
2.
Connect the adapter cable to the Jump Pack. Both blue (EC5) connectors must be plugged into the EC5
sockets on the Jump Pack. Note: either connector can be plugged into either socket.
3.
Connect the red jumper cable clamp to the positive post of the vehicle battery.
4.
Connect the black jumper cable clamp to the negative post of the vehicle battery or chassis ground (if
battery negative is connected to chassis ground).
5.
Plug the jumper cable into the adapter cables (connector only fits one way)
6.
Start the vehicle (engine cranking should be limited to 10 seconds of cranking in any 1-minute period)
7.
Disconnect negative clamp, then positive clamp after vehicle starts (recharge the Jump Pack after use)
USB Port for Charging/Powering Electronic Devices
Press the On/Off button for 1< second, the charge level indicator should light-up which is an
indication the USB port is on. The unit will automatically shut-off after a few minutes of non-use.
LED Flashlight
Press the On/Off button for 3 seconds to turn on/off the flashlight
.
CHARGING
First, connect the 100-240VAC Plug-in Charger to outlet, then connect the 5mm round charge plug to
the port on the Jump Pack, the charge level indicator light should start to cycle which is an indication
the unit is charging. When all the indicator lights remain on, the unit is fully charged.
Specifications
Model: ETX-JMP12-24
12 Volt
Peak “
Boost Amps
”
800A
24 Volt Peak “Boost Amps”
400A
Battery Capacity mAh/Wh
7800mAh/99Wh
USB Output (1 standard USB/ 2
USB-C)
5V @ 2.1A
Wall Charger Output
2A @ 15V
Max Recharge Time
2-3 hours
Weight (complete kit)
4 lb. (1.8Kg)
Weight (complete with carrying
case)
2.4 lb. (1.09Kg)
Dimensions (power pack only)
6.25in (L) x 2.75in (W) x
3.75in (H) / 160 x 95mm
