MAINTENANCE
Before carrying out maintenance operations, disconnect power supply.
Before each use
check the extension cord for
signs of damage or ageing. Replace the cable if
it is cracked, split or otherwise damaged. Check the
condition of the tines and ensure that all threaded
connections are securely tightened. If the tines
become dull or blunt, sharpen or replace them. Call
our customer service help line at 1-800-313-5111
for assistance.
Once per season
lubricate the tines and shaft. At
the end of the season, check the tiller/cultivator for
damage prior to storing. Repair or replace damaged
or broken parts.
CAUTION:
Always clean the tiller/cultivator after
each use. Failure to carry out proper cleaning can
result in damage to the tiller/cultivator or result in
poor performance.
Clean the underside of the motor support plate and
housing around the tines with a scrub brush, and a
soft cloth dampened with a mild soap and water
mixture.
Never use a water hose to clean the till-
er!
To remove soil and debris from the trans-
mission and tines, use a stiff brush or a damp-
ened cloth. Clean the vents on the motor housing
and remove any remaining grass or dirt. Once
cleaned, wipe the tines and shaft dry and apply a
light coat of oil to prevent rust.
Tines Removal and Installation (Fig. 6):
Worn
tines invite poor performance and overload of the
motor. Check tines before each use. Sharpen or
replace the tine assemblies with new ones when
necessary. Call 1-800-313-5111 for assistance.
WARNING:
Injury can occur while working on the
tines. Wear protective gloves.
To remove the complete tine assemblies from the
shaft, remove the M8 X 40 hex head bolt from the
shaft. Remove the tine assembly from the shaft.
Reverse above steps to install tines.
Replace worn or damaged parts with original
replacement parts only. Parts from another tiller/
cultivator may not fit properly causing an unsafe
situation.
Make sure all protective devices are secure and in
good condition. Repair or replace if necessary.
Lubrication (Fig. 7):
The tines drive transmission
case has grease installed at the factory. It is not
required that the grease level be checked nor
recommended that grease be added during the
first 2 years of use. After the second season of use,
follow the directions as described below:
Drain screw plugs are located on the right side of
transmission housing. Lay the tiller/cultivator on
its left side and clean the transmission of dirt and
debris prior to removing the drain screw plugs. If
necessary, remove tine assemblies to have better
access to the drain screw plug. Use a 5mm hex
key to unscrew the plugs.
Using a squeeze bottle or tube, add approximately
2.4 oz. (70ml) of auto gear lube. Do not overfill.
When completed, reinstall both drain screw plugs
into the transmission.
9
M8 X 40
M8 X 40
M8
M8
M10 X 6
7.5 X
1.8