background image

HELPFUL HINTS: READ THE DIRECTIONS BEFORE ASSEMBLY

THIS SPREADER COMES PARTIALLY ASSEMBLED, REQUIRING YOU TO INSTALL THE WHEELS, HANDLE ASSEMBLY AND 

CONTROL ROD.  IT SHOULD TAKE APPROXIMATELY 10 MINUTES WITH THE USE OF TWO 7/16” WRENCHES AND 1 PAIR 

OF PLIERS.

  Clean the impeller plate after each use. Material build up on the impeller blades will cause uneven spreading.

  Your  spreader is designed to be pushed at three miles per hour, which is a brisk walking speed.  Slower or faster speeds 

 

  Gears are permanently lubricated at the factory.  Do not open the gearbox or dirt may enter.

  When using Rock Salt remove salt from the hopper daily.  Rock Salt will reconstitute back into a solid block over night 

lubricant to prevent corrosion.

1.

 Open carton and remove the handle assembly, wheels, and spreader from 

carton.

2.

 Turn spreader upside-down on to the hopper.

         

 

90365 ICE MELT SPREADER

 

SLIDE

GEARBOX &

AXLE ASSEMBLY

Lower 

Handle

Frame 

Brace

Cross Brace

Axle Bushing

Axle

Bearing

3.

 Ensure that the axle bearings are pushed into the axle 

bushing on both sides as shown.  Install drive wheel (both 

wheels are interchangeable) to axle using pin hole nearest to 

lower handles as shown.  Insert 2” cotter pin through wheel and through axle. Bend with pliers to prevent pin from falling 

out.

4.

 Install coast wheel to axle, then using outside pin hole as shown, insert 1” cotter pin through axle (not thru the wheel).  

Bend with pliers to prevent pin from falling out. 

2” Cotter Pin

1” Cotter Pin

Coast Wheel

Drive Wheel

PLEASE CALL

 IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY QUESTIONS 

REGARDING THE SAFE OPERATION OF THIS SPREADER.   

          

SUPPORT: 574-848-7491 or [email protected] 

ASSEMBLY & OPERATION

2019 OCT REV

PAGE 1

Отзывы: