Assembly and Operation Instructions
P2170_M52164_Rev_May2020_compressed
PAGE 4
NOTE:
Notch on bearings and lower handles. Bearings
must go through flat side of lower handle (from the
outside to the inside).
NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST STEP. DO NOT OVER TIGHTEN.
Step 7:
Slide axle bushing over axle and into axle
bearing to both sides as shown.
Step 8:
Install drive wheel onto the axle and align with
the cotter pin hole nearest to lower handles as shown.
Insert 2
″
cotter pin through wheel and through axle.
Bend with pliers to prevent pin from falling out.
Step 9:
Install coast wheel onto the axle fully, then
using outside cotter pin hole, insert 1
″
cotter pin through
axle
(not thru the wheel)
. Bend with pliers to prevent pin
from falling out.
