1/4 - 20 Lock-nut
1/4 - 20 x 1-3/4” Bolt
Pivot Bracket
5.
Install handle shaft to lower handles and pivot & bracket assembly as
shown. Using 2” bolts and locknuts.
TIGHTEN BOLTS AND NUTS NOW.
PAGE 2
1/4-20 x
1-3/4” Hex Head
Bolt
Gauge &
Lever Assembly
Handle
Spacer
Upper Handles
1/4-20
Locknuts
POSITIONS
LOWER
MIDDLE
UPPER
Handle Shaft
6.
(This step is only required if you want to change the position of
the handles)
NOTE:
Upper handles have 3-positions that you can
adjust for operator comfort. If operator chooses middle or upper
positions, use handle spacer in hole nearest to handle grips. Insert
1¾” bolt through upper handle, then through handle spacer and then
through other upper handle.
DO NOT TIGHTEN LOCKNUT YET.
TIGHTEN THIS NUT LAST.
Install gauge & lever using (2) 1¾”
bolts. Be sure gauge is on left hand side. Tighten locknuts to gauge
first.
TIGHTEN NOW.
Gauge & Lever
Control Rod
Tabbed Hole
Control Rod
Lever Tension Nut
1/4-20
Hex Nuts
Pivot
Bracket
Control
Rod
7.
Install Control Rod by installing flattened end of Control Rod into Lever on
Gauge as shown. Turn to lock in place.
{Make sure that there is a plain 1/4-20 Hex
Nut threaded about halfway up the threads}
Push lever forward to full OPEN setting. Align and push the Control Rod through
the angle attached to the Pivot Bracket. Now install 1/4-20 regular nut on to
control rod.
{One nut on either side of the angled plate}
Next pull pivot & bracket back so that the shut off plate in the hopper is in the full
open position and adjust the Hex Nuts on the Pivot Bracket angle to secure the
angled bracket. Now tighten the nuts against the pivot angled bracket to prevent
change in calibration.
