To car chassis / ground
PH2200W/4
10
11
Signal Sensor:
Remote ON/Auto
ON feature (see
page 5).
Two 30A Fuses
Speaker
Outputs
Minimum
4 Ohm
Mono
The gain knob is not a volume control.
It is designed to match the input level
of the amp to the output level of the
source unit. Over driving -clipping- the
input stage of the amp will cause
damage to the amplifier (Please refer
to table for settings).
3-way switch feeds, RCA outputs
3/4 a full range, high-pass or low-
pass signal.
3-way
for each block
runs CH1/2 or CH3/4 in low
-pass, full-range or high-
pass mode.
switch
Tonal controls CH3/4:
+ 12dB boost @ 12kHz
+ 18dB boost @ 45Hz
Four RCA level inputs
with a range of 0.2V to
5V. RMS.
Set Xover knob to
Minimum (20Hz), &
set Xover switch to
by-pass, (full-range)
Specifications Are Subject To Change Without Notice
www.earthquakesound.com
To remote turn on / trigger
To battery (+)
POWER
REM
GND
BAT
Remote ON Auto ON
Four RCA level inputs
crossed outputs, can be
used to feed other
amplifiers in the system
FC6.2 Midrange
FC6.2 Midrange
FC6.2 Midrange
FC6.2 Midrange
FC6.2
Tweeter
FC6.2
Tweeter
FC6.2
Tweeter
FC6.2
Tweeter
