EarthQuake Cinenova Grande, Руководство пользователя

Страница: 8 / 16

Confirm the voltage setting of the amplifier. It must match the voltage in your
home. The amp is set by factory to either 120V or 240V. Check above the
circuit breaker for this information.
Pre-setup
Getting Started
8
Earthquake Sound
5) PLUG IN POWER CORD 6) TURN ON CIRCUIT BREAKER
4) 12VDC 3) SPEAKER CONNECTIONS
1) INPUT SELECTION 2) X-OVER MODE SELECTION
Set the input control to
either RCA or XLR. This
tells the amp which
input type will be used.
A pair of binding posts is
p r o v i d e d f o r e a c h
channel. These posts
accept bare wire, spade
lugs & banana type
plugs. If bare wire is
u s e d t h e n , s t r i p
approximately 1/2 inch
to 3/4 inch of insulation
from the end of each
wire and carefully twist
the strands of each
conductor together.
Then insert. If you plan to power the
Cinénova using an
external source. Then
you will need to plug the
source into the 12VDC
Trigger.
When using this feature
the main power switch
must remain in the OFF
position at all times.
The Cinénova Grande
h o u s e s 5 o r 7
amplification blocks.
Each block comes
equipped with a 3-way
Mode Selection switch.
Generally the amplifier
Is used in By Pass
mode and fed a crossed
signal from a processor.
U n l e s s o t h e r w i s e
desired, the crossover
switch should remain in
By Pass position.
Plug the AC power cord
into the amp first then
into the wall outlet.
Make the connection in
place firmly. This amp is equipped
with a 20 ampere circuit
breaker. Once that all
tasks have completed
then proceed to turn the
circuit breaker to the on
position.
See Page-12
For Filter
Setting
Information
WHEN APPLICABLE
Amplification Block Plate Power Plate