EarthQuake Cinenova 7300, Руководство пользователя

Страница: 6 / 12

6
specifications are subject to change without notice
1. RCA Input:
Accepts low-level signal from any source, such as a processor or receiver. From
0.4 Vac up to 6 Volt AC.
2. Input Selector:
To maintain signal integrity Cinénova 7300 provides you with an “Input Selector
Switch”. This gives you (installer) the option to select between RCA or XLR inputs.
3. Fully Balanced XLR Inputs:
We recommend the use of fully balanced XLR inputs in cases when the distance
between the Cinénova amplifier and the audio source is excessive and susceptible
to noise interference.
4. Gold Plated Speaker Output Binding Posts:
We recommend that you use a high quality wire constructed of fine, multi-strand
copper 10-gauge and up. Wire with a gauge of 16 may be used for short runs of
less than twenty feet. We do not recommend that you use any wires with a gauge
equivalent of 18 or higher due to the power loss and performance degradation.
5. 12VDC Trigger:
In order for the Cinénova 7300 Turn-ON to be controlled via another source,
connect the 12VDC trigger input to the 12VDC source output (polarity is not an
issue). From your source, 12VD should have over 20mA. Then set the manual
power switch to OFF and the circuit breaker to ON. Now any time the Cinénova
detects an incoming 12VDC signal it will automatically power on.
6. Ground Wire Binding Post:
This binding post is used for connecting a ground wire from the amplifier to your
AV receiver. We recommend that you use a high quality wire constructed of fine,
multi-strand copper 10-gauge and up.
7. AC Input Connector:
IEC Power Receptacle
8. Input Sensitivity:
Input selector gain set is based on your processor output voltage. The table
shown below reflects the signal required from your processor if you were to set
this gain based on the displayed position.
O KP
O CZ
O KP
O CZ
O KP
O CZ
O KP
O CZ
O KP
O CZ
O KP
O CZ
O KP
O CZ
Cinénova 7300 Rear Panel Overview
O KP
O CZ