7
Check for parts online at
www.getearthquake.com
or call 800-345-6007 M-F 8-5
Operator’s Manual
6015 Series CRT Rototiller
handlebar extensions
ATTACH HANDLEBAR (6015BCE, EUROPE)
1. Locate handlebar extensions.
(SEE FIGURE 2)
2. Place handlebar extensions on outside of lower handlebar
mount. Line up the handlebar extension pieces with the lower
handlebar mount as shown in the decal located on the lower
handlebar mount next to the mounting location. (SEE PAGE 21)
3. Insert one 3/8-16 x 1 3/4” bolt for each side in lower holes. Put
3/8” flat washers onto bolts.
4. Start 3/8-16 nuts on each bolt.
5. Insert one 3/8-16 x 1-3/4 bolt for each side in upper holes. Put
3/8” flat washers onto bolts.
6. Start 3/8-16 nuts on each bolt.
7. Tighten 3/8-16 nuts on each of the 4 bolts connecting the
handlebar extensions to the lower handlebar.
8. Handlebar extensions should now be securely assembled to
the lower handlebar mount.
9. Now assemble the handlebar to the handlebar extensions.
Note: Handlebar goes to the outside of the handlebar
extensions.
10. Insert one 3/8-16 x 1 bolt for each side in lower holes.
11. Start 3/8-16 nuts on each bolt.
12. Insert one 3/8-16 x 1 bolt for each side in upper holes.
13. Start 3/8-16 nuts on each bolt.
14. Tighten 3/8-16 nuts on each of the 4 bolts connecting the
handlebar to the handlebar extension.
NOTE: Handlebar extensions 13285 and 31329 can be used
together on European models.
ATTACH TINE SIDE SHIELDS
1. Locate side shields.
(SEE PAGE 26)
2. Take one side shield, raise it up against one side of the tine
guard and hold in place.
3. Place a 1/4” flat washer onto three 1/4-20 x 3/4” bolts. Insert
these three bolts in each of the three holes of the tine guard,
making sure they also pass through the side shield. Put an
additional 1/4” flat washers onto the underside of the bolts.
NOTE: The side shield needs to be below the tine hood when
they are attached together.
4. Hand tighten 1/4-20 nuts on each bolt.
5. Tighten 1/4-20 nuts on each of the three bolts connecting the
two side shields to the tine guard.
6. Repeat steps 2-4 for the second side shield.
FIGURE 2
handlebar extensions
handlebar
lower handlebar mount
cover plate
transmission
gear case
dipstick
IMPORTANT
NO ENGINE OIL!
LUBRICANT IS ALREADY
INSTALLED IN TRANSMISSION.
FILL ENGINE CRANKCASE
1. Add oil according to engine manual.
Do not overfill.
Use a
clean, high quality detergent oil. Use no special additives with
recommended oils.
Do not mix oil with gasoline.
Oil level
must be full. Check the oil level by removing oil fill plug. Oil
level should be up to the bottom of the fill plug opening.
2. Always check oil level before starting engine. Refer to engine
manual for capacity and type of oil to use.
