Earth Save Products ESP-HC-DHW 11DC, Инструкция по установке и эксплуатации

Страница: 28 / 40

27 of 39
Dated 17/09/19 V1.2
ESP-HC-DHW 11DC
ESP-HC-DHW 17DC
07 DIP switch input state 0(air source), 1(water source)
08 DIP switch input state 0(DHW invalid), 1(DHW valid)
09 DIP switch input state 0(G1 valid), 1(G1invalid)
10 High pressure switch state 1(On), 0(Off)
11 Over current protection switch 1(On), 0(Off) not valid
12 Low pressure switch state 1(On), 0(Off)
13 Inner water flow switch (for AH, GH) 1(On), 0(Off)
14 External water flow switch (for GH) 1(On), 0(Off)
15 Second high pressure switch state 1(On), 0(Off)
19 Compressor running Hz Inverter: Show actual frequency
20 Outdoor fan motor 1:running, 0:stop
21 Bent axle heater 1(On), 0(Off)
22 Four way valve 1(On), 0(Off)
23 Bypass valve 1(On), 0(Off)
24 1 electrical valve 1(On), 0(Off)
25 2 electrical valve 1(On), 0(Off)
26 3 electrical valve 1(On), 0(Off)
27 1 electrical heater 1 1(On), 0(Off)
28 2 electrical heater 2 1(On), 0(Off)
29 C4 water pump 1(On), 0(Off)
30 C5 water pump 1(On), 0(Off)
31 C6 water pump 1(On), 0(Off)
32 Accumulation days since last antibacterial 0-99
33 Cooling setting temp Real setting temp
34 Heating setting temp Real setting temp
35 Hot water setting temp Real setting temp
36 Anti-bacterial setting temp Real setting temp
37 Outdoor modular temp -30~97° C
38 Outdoor back temp -30~97° C
39 Inner pipe temp -30~97° C
40 Expansion valve open degree
41 Water source side inlet water temp -30~97° C
42 Water side leaving temp -30~97° C
43 Solar water tank temp -30~97° C
44 Inner pipe temp Entrance of the plate heat exchanger
45 Room temp display
46 Home optimization target temp Calculation
parameter A
Whilst Checking Parameters, particular care should be taken to ensure
that they are not changed.