IMPORTANT
The HUB must be turned “ON”
to link the corresponding
REMOTE headsets.
System Startup
1.
Select AC adapter or battery, then power up The HUB by
rotating the ON/OFF/Volume dial clockwise. LED confirms
power is on.
2.
Turn ON each UltraLITE headset by pressing the power
button located above the volume controls. A flashing blue
LED on the earcup confirms the headset is in search mode.
3.
Flashing LEDs change to solid blue to indicate that headsets
have successfully connected.
Set Volume
UltraLITE headsets feature 5 volume settings. Select the desired
volume by slowly clicking the up or down buttons. An audible
tone reflects volume level. A double tone indicates max volume.
Note: If using a wired headset with the HUB, adjust sound level
with volume dial.
OperaCon
Headset Adjustments
BaFery
The HUB
The HUB and all UltraLITE headsets are powered by a Lithium
Polymer battery that will operate 6 hours when fully charged.
Charging
1.
Batteries are charged via the multi-charger.
2.
Insert the batteries making sure the contacts are
properly aligned.
3.
RED: Charging; GREEN: Fully Charged.
Installation
1.
The HUB: Slide battery compartment open, insert
battery, click closed.
2.
Headsets: Press the release button located on the
bottom of the battery compartment.
3.
Insert the battery into the compartment (arrow
indicates proper direction) and snap door closed.
Low Indicator
A repetitive beep (every 20 seconds) indicates low power –
battery should be charged or replaced. to turn off.
Battery Care
To preserve optimum charge level remove battery from
headsets when not in use.
Charge Jack
On/Off & Volume Dial for
Optional Headset
Connector Assembly for
Optional Headset & Optional
Interlink.
The HUB Battery Slot
Release Button
Microphone mutes when
boom is in “UP” position.
Boom swivels so
headset can be worn on
left or right.
Position microphone one-
finger width from your mouth.
Speak into the front- indicated
by TALK.
HEADSET ON/OFF
VOLUME UP / DOWN
Conference Mode
Each time The HUB is turned on the default setting will be dual channel. Up to 4 headsets can
communicate privately on Ch 1 & Ch 2. Pressing the green conference button connects the channels
to link all 8 headsets (LED turns red).
Shut Down
Rotate The HUB on/off/vol dial until it clicks off. Press and hold power button on the UltraLITE
headsets for 4-5 seconds to turn off.
To preserve optimum charge level remove battery from headsets when not in use.
