IMPORTANT
All units marked MAIN must be turned “ON”
to link the corresponding
REMOTE headsets & CMod.
System Startup – Turn ON all units marked MAIN.
1.
Turn ON each EVADE MAIN headset by pressing the power
buJon located above the volume controls. A flashing green
LED on the earcup confirms the headset is in search mode.
2.
Select AC adapter or baJery, then power up The CMod by
rota%ng the ON/OFF/Volume dial clockwise. LED confirms
power is on.
3.
Turn ON each EVADE Remote headset by pressing the power
buJon located above the volume controls.
4.
Flashing LEDs change to solid green to indicate that
headsets have successfully connected.
Set Volume
Select the desired volume by slowly clicking the up or down
buJons. An audible tone reflects volume level. A double tone
indicates max volume.
Note: If using a wired headset with the CMod,
adjust sound level with volume dial.
OperaDon
Headset Adjustments
BaHery
The CMod
The CMod and all EVADE headsets are powered by a Lithium
Polymer baKery that will operate 6-8 hours when fully charged.
Charging
1.
BaJeries are charged via the mul%-charger.
2.
Insert the baJeries making sure the contacts are properly
aligned.
3.
RED: Charging; GREEN: Fully Charged.
InstallaRon
1.
The CMod: Slide baJery compartment open, insert baJery,
click closed.
2.
To eject baJery press the release buJon located at the top
of the compartment.
3.
Insert baJery by snapping onto place.
Low Indicator
A repe%%ve beep (every 20 seconds) indicates low power –
baJery should be charged or replaced. to turn off.
BaKery Care
To preserve op)mum charge level remove ba2ery from headsets
when not in use.
The CMod Battery Slot
Microphone mutes when
boom is in “UP” position.
Boom swivels so
headset can be worn on
left or right.
Position microphone one-finger
width from your mouth.
Speak into the front- indicated
by TALK.
HEADSET ON/OFF
VOLUME
UP / DOWN
Conference Mode
Each %me The CMod is turned on the default se`ng will be dual channel. Up to 8 headsets can
communicate privately on Ch 1 & Ch 2. Pressing the green conference buJon connects the channels to
link all 16 headsets (LED turns red).
Shut Down
Rotate The CMod on/off/vol dial un%l it clicks off. Press and hold power buJon on the EVADE headsets
for 4-5 seconds to turn off.
To preserve op)mum charge level remove ba2ery from headsets when not in use.
A - Charge Jack
B - BaAery Insert
C - On / Off Dial
D – Separate / Combine Switch
E - Interlink Jack
F - Headset Jack
G - Belt Clip
H - Programming BuAons
A
D
E
F
G
B
H
Back
Expand system - Interlink two Conference Modules.
1.
Power ON both modules.
2.
Connect with HDMI cable via interlink jack.
3.
Press ONE Separate/Combine Switch.
4.
Both LEDs will turn red
, indicaUng Conference Mode.
Interlink OpDon
C
