*
During the replacement process, please wear
gloves throughout the operation to prevent being
cut by some sharp components.
2. In front of the direction in which the headset is worn, uncover the five Velcro
shown in Figure Take out the wire connecting the earmuffs on both sides.
1. As shown in Figure 1, first remove the plug of the microphone Then remove
the rotatable parts installed on the mic Finally, separate the microphone and
headphones.
3. Select the earmuffs on either side for disassembly (the left side is shown in
Figure 3). Insert your finger into the gap between the ear pad (Part A) and the
sponge pad (Part B) as shown in Figure 2. Separate the ear cup (Part C) and ear
pads in the direction indicated by the arrow.
5. Lift the ear cup bracket (Part F) to complete separation. Use the same
method to disassemble the earmuff on the other side to completely separate
the headband and headphones.
1. Take out the M11 bracket *2 in the accessories, align the holes in the
direction shown in the figure, insert the rotating nails (component E) in the
bracket, and then install the positioning fastener (component D).
In addition, please pay attention to the position of the wire connecting the ear
cups on both sides.
2. Align the ear pads (Part B) and ear washers (Part A) on the sides of the ear
cups, and press firmly until they are fully attached.
4. Completed
3. Select the left or right side to install the microphone as shown in
Figure 8.
4. In step 1, gently remove the two positioning fasteners (part D) in part C in
the direction of the arrow, and then put them in a safe place to avoid loss.
Step 2. Continue to take out the bracket pivots (Part E) on both sides in the
direction of the arrow and put them in a safe place to avoid loss.
HOW TO REPLACE THE M11 BRACKET IN THE HELMET
M32
STEP 1. SEPARATE
STEP 2. REPLACE
A
B
C
1
2
2
D
E
F
A
B
3
2
1
1
2
3
2
2
1
2