10
CAUSE
ACTION REqUIRED
Paint too diluted
Add undiluted coating
Paint output too high
Reduce the coating output by scrolling
Paint Flow Adjuster (9) downwards
Moving too slowly
Increase speed of application
Spray trigger held too long
Release trigger sooner
Spray Gun too close
Increase the distance between the Spray
.
Gun and the work-piece
Paint too diluted
Add undiluted coating
Paint output too low
.
Increase the coating output by scrolling
.
Paint Flow Adjuster (9) upwards
Moving too fast
Reduce speed of application
Spray Gun clogged
Clean the Spray Gun
Spray Gun too far away
Move the Spray Gun closer to the work-piece
Paint too thick
Add thinners
Fluid tip clogged
Clean the Fluid Tip (5)
Pick-up tube clogged
Clean Pick-Up Tube (11)
Air hose split
Replace Air Hose (13)
Grainy coating
Filter the paint
Paint container almost empty
Refill Paint Container (12)
Spray Gun at an angle
Check that the Pick-Up Tube (11) is pointing
.
towards the paint
Air inlet blocked
Check the condition of the Filter (14) and
.
clean or replace as necessary
You move your wrist
Move your forearm instead
Paint flow not set correctly
Use the Paint Flow Adjuster (9) to control
.
the flow
Air passage is blocked
Remove the air cap retaining ring, air cap
and pattern selector. Remove the fluid tip
and needle. Using a small stiff cleaning
brush or paperclip, clean underneath the
needle chamber. Check the hole is clear by
turning the gun upside down and looking
down the air inlet. Before reassembly,
grease the fluid tip and needle. Reassemble
the gun.
PROBLEM
The paint drips
.
onto
item being painted
Paint is too thin
.
or
.
irregular
No paint being
.
released
Too much paint in
.
one area
Either too much
.
or
.
not enough paint
TROUBLESHOOTING
