![background image](http://html1.mh-extra.com/html/earlex/spray-system-hv-1900/spray-system-hv-1900_operating-instructions-manual_3421923007.webp)
7
HELPFUL HINTS
1. Evenly control the speed of movement of the spray gun. A fast speed will give a thin coat and a slow speed
will give a thick coat.
2. Stir paint well using Paint Stirrer (19).
3. Only apply one coat at a time. If a further coat is required follow the paint
manufacturer’s instructions for drying times.
4. If spraying small areas or objects keep the output setting low as this will avoid
excessive use of paints and will minimise overspray.
5. When spraying large areas or objects, it is best to use a ‘criss-cross’ pattern,
either from left to right then up or down or vice-versa. This will ensure
maximum coverage (Fig.5).
6. Avoid stopping and starting when spraying as this can lead to too much or not
enough material on a surface.
7. To ensure edges are covered, commence spraying just to the side of area
being sprayed.
8.
CLEAN SPRAYER AFTER EVERY USE (SEE CLEANING INSTRUCTIONS).
CLEANING INSTRUCTIONS
THE SPRAY GUN MUST BE THOROUGHLY CLEANED IMMEDIATELY AFTER USE. IF THE PAINT DRIES
INSIDE THE GUN, CLEANING WILL BECOME MUCH MORE DIFFICULT AND MAY RENDER THE GUN
INOPERABLE. THIS IS NOT COVERED BY THE GUARANTEE.
The spray gun is the same as a paintbrush, if it is not cleaned the paint will go hard and render the gun useless.
You must therefore clean this out after use.
SPRAY GUN
●
Remove the Paint Container (15).
●
Pour any leftover paint into its container so that it can be used for the future.
●
Pour a quantity of the respective thinners into container, shake the spray gun lightly, reassemble the gun,
then spray this liquid through the gun. Repeat this until the thinners being sprayed is coming through with
no traces of paint.
●
Clean any traces of paint off the outside of the spray gun.
●
Clean the Paint Container Seal (14) inside the spray gun body.
FLUID TIP & NEEDLE
●
Unscrew Air Cap Ring (1)
●
Remove Air Cap (2)
●
Completely remove Fluid Adjusting Screw (10)
●
Remove Spring (9)
●
Remove Fluid Needle (8) by gently pulling the Trigger (7).
●
Remove Fluid Tip (4)
●
Remove Spray Direction Plate (3) noting the position of notches.
●
Remove Fluid Tip Seal (5)
●
Remove Paint Container Seal (14)
●
Place all of these items (apart from Paint Container Seal (14)) into a container and clean them using a brush
and clean thinners
●
Clean the inside of the body of the gun
●
Thoroughly dry these parts before reassembling
●
Grease the Gland Seal (12). (USE PETROLEUM JELLY. DO NOT USE SILICONE BASED GREASE.)
●
Reassemble parts in reverse order.
It is recommended fitting the Fluid Tip (4) prior to the Fluid Needle (8).
NEVER DISPOSE OF PAINTS OR SOLVENTS INTO DRAINS. CONTACT YOUR LOCAL COUNCIL TO
ARRANGE COLLECTION OR FOR DETAILS OF NEAREST REGISTERED DISPOSAL SITE.
Fig.5
Содержание SPRAY SYSTEM HV 1900
Страница 2: ...2 IMPORTANT INFORMATION not supplied...
Страница 10: ...10 NOTES...
Страница 11: ...11 NOTES...