The 230V unit will operate for approximately
1 1/2 hrs and the 110V unit will operate for
approximately 3 1/4 hrs before requiring
refilling. The water level is shown through
the glass level indicator and should not be
allowed to fall below minimum. Switch the
unit off when this level has been reached.
If you require further use of the steamer,
ensure unit is switched off and has stopped
boiling. Wait for 5 minutes. Slowly turn cap
anti-clockwise, any remaining trapped steam
will be released from beneath cap.
Caution
- steam is very hot -wear a glove and
keep face clear.
Refill to the level indicator
as before and follow above instructions.
YOU MUST NEVER ALLOW THE UNIT TO
BOIL DRY.
There is a safety thermal cut-out device
fitted to the unit. If the unit is allowed to boil
dry this will operate and prevent further use.
Switch the unit off and allow it to cool for at
least 5 minutes, refill with water and then
switch on again - the thermal cut-out should
automatically re-set. If this has not re-set
allow a further cooling period.
When you have finished using the unit allow
any remaining water to cool and then empty
the unit. We recommend flushing the tank
out with clean water before storing. NEVER
LEAVE WATER IN THE UNIT WHILST
BEING STORED.
Storage
Brackets are fitted to the frame for the
storage of the mains lead and hose.
To recoil - wind the mains lead onto the
brackets - then wind on the steam hose
ensuring adequate length of hose is left to
secure the steamplate into the clips on the
opposite side. The handle should face
outwards - slide the plate in until tight.
Radiator Cap
To fit - screw onto the filler neck hand tight.
Do not overtighten.
To remove - ensure unit is switched off and
has stopped boiling. Wait for 5 minutes.
Slowly unscrew the cap, any remaining
trapped steam will be released from the
anti-discharge valve.
Caution - steam is
very hot - wear a glove and keep face
clear.
Refill to the level indicator as before
and follow above instructions.
STEAM IS DANGEROUS.
4
