UNPACKING AND SETTING UP
1) Remove all packing materials and accessories and lift unit out of the box.
2) Release the two tank clips and lift the motor housing off from the recovery tank.
3) Remove all components from inside the tank.
4) Turn the tank upside down and insert the 4 castors. These should be pushed in hard until they stop.
Once installed these remain in place permanently.
5) Push the Hose Inlet into the hole in the side of the Recovery Tank. The Hose Inlet must be pushed in
from the outside of the Recovery Tank ensuring that the lug on the side of the Hose Inlet is lined up
with the slot in the hole in the Recovery Tank. Grasp the Hose Inlet from inside the Recovery Tank and
pull with an up and down motion to engage. Make sure that the clips on the top and bottom of the
Hose Inlet are fixed into place inside the Recovery Tank. Once installed the Hose Inlet can remain in
place permanently.
6) Fit the outlet elbow to the outlet on the motor housing. The outlet elbow can be used to deflect airflow
from the motor away from the work area.
3
COMPONENTS
The following components are included in the kit (as illustrated below)
WD0001 Recovery Tank
WD0036 Crevice Tool
WD0026 Extension Tubes x 2
WD0037 Floor Head
WD0045 Castors x 4
WD0050 Hose
WD0082 Motor Housing Assembly
WD0035 Hose Inlet
WD0147 Outlet Elbow
WD0178 Combined Filter
WD0188 Dust Collection Bag
WD0181 Power Tool Adaptor
WD0327-06-11.qxd:WD0046-03/05.qxd 9/6/11 09:19 Page 3
