The material contained in this document is the property of Electronics & Innovation Ltd., it is
subject to change without notice.
December 2015
7
Revision F
In the default state, the RS-232 port will echo the same information sent to the
front panel LCD display, allowing a running datalog to be stored to disk using the
capture feature of the terminal program.
Single character commands can be sent to the amplifier to achieve the following:
"1" key enables telemetry (readback similar to LCD display) - this is the default
mode at power up
Custom commands and display lists can be implemented upon customer
request.
Chapter 3 Technical Description
3.1 GENERAL DESCRIPTION
The 350L is designed to amplify signals by 50 dB in the frequency band of 250
KHz to 150 MHz. The signal from the front panel N connector is fed via a length
of 50 ohm coaxial cable into the input of the driver amplifier module. The signal
from the input of the driver is coupled to the input of the MMIC front end. The
output signal of the MMIC is coupled to the gate of transistor Q1. The further
amplified signal appearing at the drain of Q1 is coupled to the input of Q2. This is
transformed to 50
and fed to the driver output port.
The driver output signal is fed through a length of coaxial cable to a two way
splitter and then to a four way hybrid splitter, to the individual power amplifier
modules. The output of each amplifier is then combined in a four way hybrid
combiner and the two modules are then combined in a two way.
The power amplifier output signal is then fed into a length of 50 ohm coaxial
cable to the RF bi-directional coupler. The output of the coupler is then fed
directly to the N connector on the front panel, this is the unit output.
The forward and reverse coupled ports of the bi-directional coupler are fed to the
RF detector which is situated on the main control board. The RF detector feeds a
voltage, which is representative of the true RMS power to the control board
proper. The control board in turn drives the front panel display.
The main power supply unit provides a 24 VDC 24 ampere source. It is a switch
mode power supply unit. The output feeds the PA and driver. The main power
supply also has a 5 VDC output which feeds the control board.
Block Diagram See Appendix A
