5
.
Carefully remove the plastic push fastener securing the electrical wire
harness to the core support.
6
.
Apply masking tape to the fender and front moulding where they
meet. Apply masking tape across the forward edge of the hood at
this time (not shown).
Copyright 2015 by E&G Corporation, LLC.
Visit us online today at www.egclassics.com
7
.
Remove the factory push fastener at the top of the front moulding.
8
.
Use a 7mm socket to remove the two hex screws from the wheel
opening.
7
8
9
.
Pull out on the headlight surround to seperate it from the mount-
ing channel of the front fender.
9
5
6
10
.
Pull forward on the top of the headlight surround to unclip and re-
move it from the vehicle to expose the factory grille lower mount-
ing hex screws.
