16
Place the transducer into the epoxy, twisting and turning it to force
any air bubbles out from under the transducer face. The face of the
transducer should be parallel with the hull, with a minimum amount
of epoxy between the hull and transducer. After the epoxy dries,
route the cable to the sonar unit.
Speed/Temperature Sensors
The FishEasy 2 family can accept as many as two temperature sensors,
which can be used to monitor the temperature of surface water, a live well
or some other location. These units can accept an optional speed sensor
for showing speed and distance traveled. However, you can only use one
accessory at a time. If you would like to use a speed sensor and a tem-
perature sensor at the same time, you will need a combination device.
NOTE:
The FishEasy 2T and SeaFinder 240DF are packed with transduc-
ers containing built-in temp sensors. The SeaFinder package also
includes a speed sensor. If you have another model and want a
speed or temp sensor, see the Accessory Ordering Information in
the back of this manual.
If a
second
temp sensor is used, it must be the model TS-2U. This
model has a fixed electronic "address" which designates it as the second
of two temp sensors. Dual temperatures are
only
displayed on the Full
Chart page. The Large Digital page will only display the
primary
tem-
perature sensor.
Full Chart page showing dual temperature display.
See the following charts for sample sensor combinations and cable con-
nections.
Primary temp sensor
built into transducer
TS-2U secondary
external temp sensor
shown as T2