24
"Speaker" label, then press the left arrow key to turn it off.
System Information
This screen shows some basic data about the Ultra Classic. To view this,
highlight the "System Info" label on the System Setup menu, then press
the right arrow key. The system info screen appears. To erase this screen,
press the EXIT key. The Ultra Classic returns to the System Setup menu.
Units of Measure
The Ultra Classic normally shows the
depth in feet, speed in statute miles
per hour, distance in statute miles,
and temperature in degrees Fahren-
heit. You can change any of these
settings using the units of measure
menu. To do this, highlight the "Units
of Measure" label on the System Setup
menu, then press the right arrow key.
The screen at right appears. Highlight
the item you want to change, then
press the right or left arrow key to
change it. To erase this screen, press
the EXIT key.
Reset Distance Log
If you have a speed sensor attached to the Ultra Classic, the unit starts
counting the distance you've travelled each time you turn it on. You can
reset this distance to zero by turning the unit off and on again, however,
it's easier to highlight the "Reset Distance Log" label on the System Setup
menu, then press the right arrow key. This resets the log and keeps you
in the System Setup menu. To erase this menu, press the EXIT key.
Temperature Graph
Some of the Ultra Classic's screens have a
temperature graph, as shown at right. Nor-
mally, the temperature graph has a 2° range.
On the screen shown at right, the tempera-
ture graph has a range from 72° to 74°. You
can change this range to 4° or 10° using the
"Temp Graph" label on the System Setup
menu. Highlight that label, then press the
right arrow key until the desired temperature
graph range is highlighted. Press the EXIT
key to erase the menu.
